Bosch Pressure Sensor - 0261230236

Bosh required for import cars this Bosh part cleared my code on my Volvo 👍🏼

So I waited over a whole year before leaving this review because I have had bad luck in the past with online buying sensors. But I got this in early June of 2022. It took me a total of maybe 10 minutes to replace the fuel rail sensor. So far 1 year later after installing the issue has Not come back. I improved my MPG by 9 MPG after install and have no seen any power loss or hesitation from the repair.I recommend searching online auto suppliers or your vehicle manufacturer for the correct part number before ordering on here. I searched on Amazon for my fuel rail sensor and it came up with 5 different part Number's that would fit. And after searching on my vehicle's manufacturing site only 1 of the part numbers would fit correctly.But all in all the replacement part has worked great.

Works great

Works as intended. Just be careful with these..some are for normal aspirated engines....the Grey ones

I swapped the sensor for this one and it seemed to fix the problem although I will intermittently have a hard startup. Hard to tell if it is the new sensor or another pre-existing problem but the symptoms are the same as with the faulty (old) sensor, just not as frequent

Fast delivery. Minimal packaging. Sticker on the box indicated this was a genuine Bosch part from Germany. Installed it in an '08 Volvo S40 2.4i (automatic) following online tutorials and suggestions. Space is super tight to remove/install this part and you'll need torx bits T30 and T25 for the cover and part, respectively. I ended buying a right angle screwdriver and bits from the local Harbor Freight to solve that issue. Definitely be sure to have rags in place to catch any fuel that spills out! I followed directions to relieve fuel pressure including removing the proper fuse and also depressing the relief valve. I thought I was in the clear since no fuel came out from the relief valve but when I removed the sensor, I good bit of fuel spilled out. It was all absorbed by the rags so it didn't end up on the alternator. After I got everything back in place and let the gas fumes clear, I started the car with no issue and the CEL was cleared. It's been close to a month now. No issues.

Fixed problem

Got this from amazon, It came in original box and wrapped in plastic, the plastic was stretched and was a little dirty from a garage. I put some on my truck two months ago and they're without a doubt the best product I've installed. My f150 got these and I honestly wouldn't buy anything else. Please keep in mind I'm aware there's better products available at much higher prices but I'm not a race driver on a closed course, neither is half the folks who run them but that's their money, but for my money I refuse to buy cheap off name brand junk, and draw the line at really high priced stuff that earned their reputation from spending money advertising rather than research, I usually go with mid priced stuff such as these and I found a real gem with these, I'd definitely recommend this to someone!