Husky LinersRear Wheel Well Guards | Fits 2021-2024 Ford F-150 (Fits Raptor Model ONLY), Rear Set - Black, 2 pc. | 79171

Fit great, leaves the shocks exposed like I hoped. Install took maybe 15 minutes, some tips:1. I only backed the flare screws out halfway, I didn’t remove them.2. Get the liner in at the bottom corners first, then work your way from the tailgate end first and around towards the front of the vehicle side of the wheel well - goes much easier!3. Use a plastic trim tool like the one in my picture, saves your fingers and it makes the install a breeze. Only had to drag that tool around the fender and it set everything perfectly and quick versus pinching my fingers and fighting it in between the flare and the body. This way you pull the flare down and the liner slips in perfectly. LWith the tool, I did each side in under 5 minutes. Without the tool, still simple but it might take 20-25 minutes of fumbling around with it.

Required some fitting but the seller made it right! Buy with confidence

Do not purchase from this company. If I could give them a -trillion I would. I tried to return there product that seem to me to be defective from the manufacturer. It didn’t fit. They sent me a return label that only included the label not prepaid and told me to pay return cost. Took it ups store $400 was there cost. After multiple emails over 4 days they sent a pre paid return label and still haven’t received my refund. What a joke of a company.

Great product. Make sure you order the correct one. Once correct ones are in hand they are a snap to put in!

Easy to install. Will require you to do a little finessing to get the liner between fender trim and fender. Take your time to prevent scratching fender trim. Looks amazing!

These look great and I've held up well and after installed no worries at all. Installation was a little awkward, but they did go in eventually....

Fit good

Do not purchase if you have 802A package with the dual valve shocks and 37s. They DO NOT fit raptors with those shocks. Only fits the 801a package with normal suspension/35s. Support is garbage and kept saying they can "fit" - sure if you cut and dremel out the plastic but that shouldn't be the case. You are at risk if not done appropriately on having the plastic damage the wiring nearby etc. Don't waste your money.